Plantonic 1000
The PLANTONIC 1000 is our large-area electroculture solution. Equipped with two 10W photovoltaic panels and a waterproof electronic box, it stimulates up to 1000m² entirely off-grid.
Technical specifications
Area
500 to 1000 m²Suitable for large plots (50m × 20m)
Power
2 × 10W solarTwo separate photovoltaic panels, fully autonomous
Impact
Zero carbonEnergy-autonomous, no consumables
Installation
February – MarchStart at the beginning of the season to stimulate the soil
Large-scale electroculture
The Plantonic 1000 consists of a waterproof box and two separate 10W photovoltaic panels. When the unit is running, two LEDs flash on the front, indicating that stimulation is active. A third LED indicates that the panel has sufficient light.
The PLANTONIC 1000 stimulates a 50m × 20m surface, i.e. nearly 1000m². Stimulation starts even with overcast skies and peaks in full sunlight. The unit can be adapted to plots from 500m² to 1000m².
The unit has internal settings to configure during installation. They allow you to fine-tune the stimulation to the plot’s surface: electrode length and electrode spacing.
- Two 10W photovoltaic panels → fully autonomous
- Waterproof electronic box with indicator LEDs
- Adjustable settings for plot adaptation
- Covers 500 to 1000m² of crops
- 50% to 100% growth increase depending on plants
- Compatible with BOOSTER to stimulate mycorrhization
Pack contents
Solar panels
2 × 10W solar panels + 10 metres of cable
Extension cables
2 × 25-metre electrical extension cables
Accessories
2 clamps for 10/12 tube + 2 plastic caps
Coverage diagram
Plantonic 1000 stimulation zone → Area of 500 to 1000m² between the electrodes
Copper electrodes
The electrodes are made of 12 or 14mm copper tube (available in DIY-store rolls). The tube is placed 20cm into the soil on the EAST and WEST sides, with the ends bent to form a U-shape. The two ends stick out of the ground.
The electrical wire connects to the PLANTONIC unit via a clamp, then is covered with tape to ensure water-tightness. The tubes are sealed with the rubber caps provided.
Electrode installation
Performance and area of influence
The Plantonic 1000 shows significant efficacy on plant growth. Depending on the plants, growth increase ranges from 50% to 100%.
The direct area of influence sits between the electrodes. An additional egg-shaped zone also influences plants around the main rectangular zone. It stimulates growth and health of vegetable plants, flowering plants and fruit trees, even when diseased or weakened.
The Plantonic 1000 can also be used to stimulate rooting and growth of hedges along a 50m length with 2m electrodes. The Plantonic acts immediately and stimulates the soil gently and constantly — no sudden burst like a fertiliser shot.
Area of influence
Direct area of influence (dark green) and extended zone (light green) of the Plantonic 1000
Using the BOOSTER
The liquid BOOSTER, delivered in 2 small bottles, is poured directly into the copper tube of each electrode. Top up with demineralised or osmosed water up to 3cm from the top of the tube. Then seal both ends with the caps.
Rainwater is polluted and tap water is chlorinated — avoid using either with the BOOSTER. Use only demineralised or osmosed water.
Interested in the Plantonic 1000?
Contact us with details of your project, the dimensions and orientation of your plot. We’ll send you a personalised offer with a free study for electrode placement.
Contact us2026 Price List
Check our full price list for all Plantonic electroculture devices and accessories.
Download the price list